Automation Parts

Murata Power Inductors Support 8A-Rated Current Murata has introduced the LQH88P_38 series of power inductors, supporting up to 8A-rated current. The inductors measure 8 x 8mm (3131-size) with a profile of 3.8mm (typical) and are designed for use in DC-DC converters for flat-panel TVs, set-top boxes, recording devices, wireless base stations and other consumer-electronics applications. The LQH88P_38 series is said to possess excellent DC bias current characteristics, saving space for customers by replacing larger-size or higher-profile inductors. The parts are magnetically shielded by ferrite resin to prevent interference with other devices and circuits. Low DC resistance (down to 0.006Ohm) and high-rated current parts are available. The LQH88P_38 series comes in inductance values between 1.0 and 100uH.

Panel Thermostats Offer Peak Current Rating Of 10A The 1T series of panel thermostats from Finder are aimed at designers and manufacturers of electrical control panels, motor control centres, distribution and server cabinets and automation systems. They are designed to maintain acceptable ambient temperature levels in electrical control panels and enclosures by controlling on/off status of heating and/or ventilation components. The thermostats are ideal for use in controlling heating and ventilation within panels and equipment installed in areas subjected to wide variations in ambient temperature, and where temperatures inside enclosures are likely to rise considerably due to the normal operation of equipment and components contained within. Reliability is the main factor driving the demand for this type of thermostat by reducing damage to, and minimising the potential failure of equipment caused either by the effects of overheating or by condensation resulting from rapid cooling. ...

Monitoring or controlling motors, heaters, or other power consuming electrical devices has never been easier. With Red Lion's New Non-Contact Current Transducers you can convert those high level current signals into simple 4 - 20 mA or 0 - 10 VDC process signals. These new sensors are available in solid core cases for new wiring, and split core cases to simply clamp over existing wiring. They are perfect for long cable runs and very cost effective. The model CTD is a DC current transducer combining a Hall Effect sensor and a signal conditioner in a single package. The CTD has jumper selectable input current ranges of 50A, 75A, and 100A and provides a self-powered 4-20 mA output. It is available in a split case model only. The model CTL average responding AC current transducers combine a current transformer and a signal conditioner in a single package. The CTL transducers are designed for use with “linear” or sinusoidal AC waveforms, and are best suited for constant speed loads...